Fabrication and Assembly Guide

From UCLA Miniscope
Revision as of 16:09, 28 April 2015 by DAharoni (talk | contribs) (Ordering standard parts)

Jump to: navigation, search

This page will walk you through the steps of building your own MINIscope system.

Ordering custom parts

The filter set, MINIscope body, and Printed Circuit Boards (PCBs) need to be custom made. Below you will find all the information you will need to order these parts.

Filter set

MINIscope housing

Printed circuit boards

Ordering standard parts

Screws, magnets, and wires can all be ordered through McMaster-Carr.

Electronic components can be ordered though Digikey.

Optical lenses can be ordered through Edmund Optics.

Grin lenses can be ordered through Grintech.

Please refer to the part list for part number and supplier.

Assembling MINIscope housing

Building cables

Assembling electronics

Flashing DAQ firmware

Installing DAQ software